build it right (the first time!)

Thanks for choosing a locker from our brand new Glass Collection!

Your locker was made in our very first round of production. Lucky you, you got your hands on a first edition!

As with most first tries, there are things we learn along the way. We've made a few small changes for our next round of production, but with these handy hints, you can build your locker right on the first try and you won't have any troubles. These little extras won’t affect the look or function of your locker at all, there's just a couple of things we need to let you know:

Building a Collector, Mixer or Kit?

When it comes time to add your doors, you'll notice there are two holes on the bottom of the door frame, one bigger, one smaller. Make sure you slot the post into the small hole and you'll be all set! This ensures the door will close nice and smoothly. If you accidentally put the post into the big hole and have attached the top with the spring post, don't panic! You can use a flathead screwdriver to push down the spring in the door through the rectangular hole. Do this carefully so that it's low enough for the door to pop out. Then try again, aiming for the small hole!

Building a Kit?

When you slot the U bar under the back edge of your Kit, make sure you can see the four holes in the side of it. These holes should be facing inwards, you’ll need these in a few steps time. That's it!

If you need anything, we're always here to help. Send us an email if you have any questions!